New release: Veritas trimmer router table

Comments Comments


Designed for use with trimmers, this benchtop table is the ideal complement and designed with stability, safety and control in mind. On top of that, it’s compact, portable and easy to store.


The 390mm × 290mm tabletop is made from 18mm Baltic birch ply with a low-friction laminate surface. Designed to accept Veritas compact router base plates there are in-built levelling screws for fine-tuning the base plate height flush with the table surface.


Two of the levelling screws also accept mounting bolts for attaching the base plate to the table. One of those mounting screws can be replaced with the included pivot post for routing curves without the fence.


The 14-inch machined aluminum fence has 190mm long laminate-clad sub-fences that adjust to accommodate bit profiles for zero-clearance routing. Integral top and face T-slot tracks can be used for mounting jigs and accessories, such as the included clear acrylic safety shield.


Changing bits is easy – either slide the barrel of your trimmer out of the base (leaving it attached to the plate) for easy access to the collet nut, or remove the two mounting screws and pull the entire trimmer through the table opening for bit changing (or freehand use).

Available from Carbatec. Pricing and more information here.


comments powered by Disqus